Italab

HF 1000 PCB

SUPPORTO IN RAME PER HF 1000

GROUND COPPER SUPPORT, 10 mm THICK, PRE-DRILLED AND THREADED, FOR HF 1000 PCB

HF 1000P50 - 1 KW, 1.6 - 50 MHz.

PALLET AMPLIFIER FOR HF SELECTION, OUTPUT POWER 1KW 1.6 -50 MHz, MAIN POWER SUPPLY 45-50 Volt, 26-29 A. DRIVING 5-10 W. PALLET IS EQUIPPED WITH INPUT ATTENUATOR 10dB 100W DESIGNED FOR CONTINUOUS SERVICE (WITH PROPER VENTILATION), A WIDE COPPER BASE ENSURES A PROPER HEAT DISTRIBUTION PRODUCED BY MOSFET AMPLIFIER.
SIZE: 160mm x 70mm x 41,5mm

MD 1K AR 50 - 70 , 1000 Watt da 50 MHz. 700 W 70 MHz

NEW RF PALLET AMPLIFIER 1000 W OPERATING 47 TO 74 MHZ,

PILOT 4 - 5 W
P.OUT = 1100 W
Vdd = 48.5 Volts
I.A. 31 - 33 A
FUNCTION CLASS: AB
OPERATING MODES: ALL MODE

AMP 1000 - AR144LB - 1 KW 144 MHz,

DEVELOPED FOR BROADCAST APPLICATIONS, THIS LDMOS AMPLIFIER IS ABLE TO ACHIEVE AN OUTPUT POWER ON 50 OHM OF 1KW AT 144 MHz . IF PROPERLY COUPLED, IT IS SPECIFIC TO BE ADOPTED INTO RADIO AMATEUR SYSTEMS WITH OUTPUT POWERS FROM 1 TO 10+ KW.
ITS HIGH EFFICIENCY (MIN. 70%) ALLOWS A REAL SAVING ENERGY (COST EFFECTIVE) AND SIZES REDUCTION FOR DEDICATED TRANSMISSION APPLICATIONS.
MOREOVER, IT IS COMPACTED (LOW WEIGHT AND MECHANICAL SIZES).
THE PRODUCT IS AT THE STATE OF THE ART WITH A GOOD RATIO PRICE /PERFORMANCES.
ITS HIGH LINEARITY MAKES IT SUITABLE TO BE USED IN SSB AND EME (AT FULL POWER, BUT IT MUST BE PROPERLY COOLED).

MD1K-AR432 - 1 KW 432 MHz

New Pallet Amplifier 1 KW 430 MHz. Uses only a MOSFET (Freescale). This solution allows to realizare an amplifier without the use of expensive couplers thus reducing the size. Mounted on a base of copper with 10 mm thickness, cs golden and metallic, Bias independently for each "Gate".

Power supply: 48 -50 Volt, 29-31 A
Piloting: 18 -20 W
Dimensions: 100 x 150 x 30 mm